reducer-圣霖国际【客户至上】-reducer厂家

减速机内部齿轮的齿距和压力角 小齿距能保证有较多的轮齿同时接触，齿轮重叠增多，减少单个齿轮挠曲，降低传动噪声，reducer生产商，提高传动精度。较小的压力角由于齿轮接触角和横六角空心砖模具向重叠比都比较大，因此运转噪声小、精度高。

The tooth distance of the gear in the reducer and the small pitch of the pressure angle can ensure that there are more teeth at the same time， the overlap of the gear is increased，reducer厂家， the deflection of the single gear is reduced， the transmission noise is reduced， and the transmission precision is improved. The smaller pressure angle is due to the larger contact ratio between the gear contact angle and the six corners of the hollow brick mold，reducer， so the running noise is small and the accuracy is high.

减速机的种类：一般的减速机有斜齿轮减速机(包括平行轴斜齿轮减速机、蜗轮减速机、锥齿轮减速机等等)、行星齿轮减速机、摆线针轮减速机、蜗轮蜗杆减速机、行星摩擦式机械无级变速机等等。

Type of reducer

The general reducer has helical gear reducer (including parallel shaft helical gear reducer， worm gear reducer， bevel gear reducer， etc.)， planetary gear reducer， cycloid pin reducer， worm gear reducer， planetary friction mechanical stepless speed change machine and so on.

减速机内部齿面硬度 随着齿轮硬齿面技术的发展，其承载能力大、体积小、重量轻、传动精度高等特点使其应用领域日趋广泛。但为获得硬齿面采用的渗碳淬硬使齿轮产生变形，导致齿 轮传动噪声增大，寿命缩短。

With the development of hard tooth surface technology， the internal hardness of gear reducer has been widely used because of its large bearing capacity，reducer型号， small volume， light weight and high transmission accuracy. But the carburizing and hardening used to obtain the hard tooth surface causes the deformation of the gear， which results in the increase of the noise of the gear transmission and the shortening of the service life.